Friday, March 1, 2013

The Type IV modem of Dataone consists of 4 LAN ports and and a Wi-Fi   router. This guide will help you to configure the modem for using   DataOne Broadband in PPPoE mode, so that you dont have to wait for the   lazy BSNL fellows. The guide uses Windows XP as the OS and IE (v8 RC1)   as browser.

Configuring in PPPoE Mode(Always On):
This   is the mode set by BSNL fellows. If u configure BSNL modem in this   mode, you can access Broadband in alwayson mode, i.e you can just on   modem and start using internet.
1.After connecting the modem to the   computer using the LAN cable, power on the modem and open Network   Connections from Control Panel.

2.Right   click on the icon named Local Area Connection, select properties.   Select Internet Protocol(TCP/IP) and click on properties.

3.In   the Internet Protocol(TCP/IP) Properties dialog box   enter the following values, after you make sure that you have selected   the radio buttons, Use the following IP address and Use   the following DNS server addresses.
IP   Address : 192.168.1.x(where x =2 to 255)
Subnet Mask : 255.255.255.0
Default   Gateway: 192.168.1.1

Preferred DNS Server: 208.67.222.222
Alternate   DNS Server: 208.67.220.220
4. Now click OK twice to close both   the dialog boxes.
5. Now open your browser(preferably IE since all   the BSNL sites are designed to suite IE).
Type http://192.168.1.1/ in the address bar.   You will be navigated to the screen below:


Enter username and password both as admin.

6.Navigate   to Advanced Setup->WAN by selecting from the left   margin.
Your screen should be like this.



7. Click Edit on the service pppoe-0_35_1.
If   you dont have the above service in the above list, click on Add   below.

8. Next you will be getting a series of windows,   described below(irrespective of whether you click add or edit).   Click on next after each step to reach the next one.

i) ATM   PVC Configuration.
Enter the following values: VPI   = 0, VCI=35 and uncheck Enable VLAN Tagging   also the Service CategoryUBR Without PCR.

ii)Connection   Type
Select PPP over Ethernet(PPPoE), and Encapsulation   Mode as LLC/SNAP- BRIDGING.

iii) PPP   Username and Password 
Enter the following details:
PPP   Username: username provided by BSNL.
PPP Password: password provided   by BSNL
PPPoE Service Name: DataOne
Authentication Mode: Auto


Uncheck   all the check boxes except the last one(Bridge PPPoE Frames   between WAN and Local Ports).

iv) Network   Address Translation Settings 
Uncheck Enable   NAT, Enable Firewall, Enable IGMP Multicast, and check Enable   WAN Service.
Service Name: pppoe_0_35_1

v)   WAN Setup - Summary
You will   finally get the following page:



Click on Save.
9. You will return to the WAN   Setup page. 
Click on Save/Reebot and wait till the modem reboots   and displays the Device Info->Summary page.
10.   Restart the browser and start browsing the net.
Please pour in   your queries as comments.


You can also refer this official BSNL link


Video Tutorial for WA3002G4, UT200R2U,DNA-A211-I (all has similar UI)



Hope you like it. Use Facebook " Like ", Twitter and + 1 buttons to share. :)

1 comment: