SPECIFICATIONS
Title of the project : Infrared
communication between PC to PC
Domain : Embedded Systems Design
Software : Assembler, Proload
Microcontroller : 89S52 CISC Micro Controller
Power Supply : +5V, 500mA Regulated Power Supply
Display : a) LCD, HD44780 16-character, 2-line (16X2)
b)
LED 5mm
Crystal : 11.0592MHz
Sensors : IR transmitter and IR receiver
Applications : Homes, offices, shops etc
ABSTRACT
This Project Automatic
Room Light Controller with Visitor Counter using Microcontroller is a reliable
circuit that takes over the task of controlling the room lights as well us
counting number of persons/ visitors in the room very accurately. When somebody
enters into the room then the counter is incremented by one and the light in
the room will be switched ON and when any one leaves the room then the counter
is decremented by one. The light will be only switched on until all the persons
in the room go out. The total number of persons inside the room is also
displayed on the LCD display.
The microcontroller does the above job. It receives the signals from the sensors, and this signal is operated under the control of software which is stored in ROM. Microcontroller AT89S52 continuously monitor the Infrared Receivers, When any object pass through the IR Receiver's then the IR Rays falling on the receiver are obstructed , this obstruction is sensed by the Microcontroller.
The microcontroller does the above job. It receives the signals from the sensors, and this signal is operated under the control of software which is stored in ROM. Microcontroller AT89S52 continuously monitor the Infrared Receivers, When any object pass through the IR Receiver's then the IR Rays falling on the receiver are obstructed , this obstruction is sensed by the Microcontroller.
This project uses regulated 5v, 500mA power supply. 7805, a three terminal
voltage regulator is used for voltage regulation. Bridge type full wave
rectifier is used to rectify the ac output
of secondary of 230/12v step down transformer.
BLOCK DIAGRAM
0 comments:
Post a Comment