Configuring BSNL DataOne Broadband for UTStarcom WA3002G4(Type IV) modem.

The Type IV modem of Dataone consists of 4 LAN ports and and a Wi-Fi router. This guide will help you to configure the modem for using DataOne Broadband in PPPoE mode, so that you dont have to wait for the lazy BSNL fellows. The guide uses Windows XP as the OS and IE (v8 RC1) as browser.

Configuring in PPPoE Mode(Always On):
This is the mode set by BSNL fellows. If u configure BSNL modem in this mode, you can access Broadband in always on mode, i.e you can just on modem and start using internet.
1.After connecting the modem to the computer using the LAN cable, power on the modem and openNetwork Connections from Control Panel.

2.Right click on the icon named Local Area Connection, select properties. Select Internet Protocol(TCP/IP) and click on properties.

3.In the Internet Protocol(TCP/IP) Properties dialog box enter the following values, after you make sure that you have selected the radio buttons, Use the following IP address and Use the following DNS server addresses.
IP Address : 192.168.1.x(where x =2 to 255)
Subnet Mask : 255.255.255.0
Default Gateway: 192.168.1.1

Preferred DNS Server: 208.67.222.222
Alternate DNS Server: 208.67.220.220

4. Now click OK twice to close both the dialog boxes.

5. Now open your browser(preferably IE since all the BSNL sites are designed to suite IE).
Type http://192.168.1.1/ in the address bar. You will be navigated to the screen below:




Enter username and password both as admin.

6.Navigate to Advanced Setup->WAN by selecting from the left margin.
Your screen should be like this.




7. Click Edit on the service pppoe-0_35_1.
If you dont have the above service in the above list, click on Add below.

8. Next you will be getting a series of windows, described below(irrespective of whether you click add or edit). Click on next after each step to reach the next one.

i) ATM PVC Configuration.
Enter the following values: VPI = 0, VCI=35 and uncheck Enable VLAN Tagging also the Service Category: UBR Without PCR.

ii)Connection Type
Select PPP over Ethernet(PPPoE), and Encapsulation Mode as LLC/SNAP- BRIDGING.

iii) PPP Username and Password 
Enter the following details:
PPP Username: username provided by BSNL.
PPP Password: password provided by BSNL
PPPoE Service Name: DataOne
Authentication Mode: Auto


Uncheck all the check boxes except the last one(Bridge PPPoE Frames between WAN and Local Ports).

iv) Network Address Translation Settings 
Uncheck Enable NAT, Enable Firewall, Enable IGMP Multicast, and check Enable WAN Service.
Service Name: pppoe_0_35_1

v) WAN Setup - Summary
You will finally get the following page:

Click on Save.

9. You will return to the WAN Setup page.

Click on Save/Reebot and wait till the modem reboots and displays the Device Info->Summarypage.

10. Restart the browser and start browsing the net.

Please pour in your queries as comments.